Home / Shower Valve Installation & Repair
Greater Lansing service
Shower and tub valves repaired or replaced to fix drips, temperature swings and stiff handles, including cartridge replacement and new trim.

Symptoms
The showerhead drips after it's turned off, the water goes scalding or cold when someone flushes, the handle is stiff or spins without changing the temperature, or water keeps coming from the tub spout with the diverter up. All of these trace back to the valve behind the wall.
Repair
Often, yes. Many problems come from a worn cartridge or seals, which we replace from the front after removing the handle and trim. When the valve body itself is cracked, corroded or an outdated design without parts, replacing it means getting behind the wall, usually through an access panel or the tile.

Upgrading
Newer pressure balancing valves keep the water temperature steady when another fixture is used, which matters in a busy house. Replacing the valve is also the time to change the trim to match a bathroom update.
Questions
Your valve isn't balancing pressure. Flushing pulls cold water away from the shower. A worn cartridge or an older valve design is usually the cause.
Yes, as long as the new trim is made for your valve brand and model.
No, but it wastes water and usually gets worse. Fix it before the drip turns into a steady stream.
Related services

Bathroom sink faucets installed and replaced, from single hole to widespread models, including a new drain assembly and supply lines when needed.
Learn more
Gas and electric water heaters repaired and replaced when hot water runs out early, the tank leaks or the heater stops lighting.
Learn more
Leaking supply and drain pipes found and repaired, from a drip under the sink to a burst pipe in the basement ceiling, any time of day.
Learn moreReviews
What people around Lansing say after we've been out.
Get in touch
Tell us about the shower valve installation & repair job and we'll get back to you, or call for help right away.
Call Us(517) 878-9438